2

I want to make several resin casts using a featureless spherical silicon mold. The mold only has a diameter of 6 cm (think paperweight or billiard ball with a tabletop miniature sealed inside), but I'm looking to make 30+ of them. So I'm going to need quite a lot of resin.

Are there any chemicals that are more affordable than the resin itself that I can use to dilute it so that it will go further?

I understand that this would effect things like drying time, but that is not necessarily an issue.

I ask as I often dilute other substances that are typically used undiluted, and it's usually the case that the substances are sold in a format that's most convenient for off-the-shelf use, rather than because it's the only way to use them.

2
  • Sealing a miniature in resin without pesky air bubbles clinging to all the nooks and crevices is almost impossible without a vakuum chamber. The proportions might also look off if you seal a standard human sized miniature (3 cm) in a 6 cm ball. More than half of the volume will just be empty space.
    – Elmy
    Aug 29 at 8:55
  • Likely a chemist could dilute it. Many "epoxy" products are actually polyester ; usually they are diluted with styrene before the consumer gets them . Further dilution would deteriorate the cured properties. Aug 31 at 21:07
4

The miniature sealed inside implies you want clear resin so you can see the miniature (not a secret miniature that someone would take your word is in there). For this requirement, there really isn't a material you can use to dilute the resin.

If the resin could be opaque, you could use a small amount of resin as a binder for a lot of cheap, solid filler. You can add up to a few percent of an appropriate liquid dye for color (the liquid is compatible and has a similar refractive index). But even with that, you can't go over a tiny percentage without affecting the resin, and if the material has a different refractive index, the result will look cloudy or distorted. Solid, clear filler, like clear plastic chips or glass beads or powder, will have a different refractive index and will be visible.

For a clear result, you also have the issue of thorough mixing and no air bubbles. Blending in another material tends to introduce air bubbles unless you have a vacuum chamber.

Unfortunately, resin isn't cheap. It's great stuff, but if you want to make things from it, it comes at a price.

1
  • 1
    I'll add scenery as a filler to save resin. Maybe make backgrounds solid instead rad of hollow Sep 1 at 7:15

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.